But we had to install 1 2 inch tile backerboard to bring the tile up and over the tub lip.
Tile over cement block.
The easiest product to use on a cinder block wall is.
Ceramic and porcelain tile are so frequently installed at or above grade level on a cement board underlayment or directly on plywood that it almost seems novel to install tile directly on concrete.
Mix surface bonding cement with water to a pasty consistency.
Answer it is possible to bond porcelain tile to a painted surface but it isn t recommended because the overall tile attachment is limited to the strength of the bond of the paint to the concrete.
Wet a section of the wall again to.
Clean debris off the wall with water and a sprayer.
For application over an uneven concrete surface a lightweight waterproof construction board must be used as an alternative to concrete board in a tile installation.
Clean the surface of any dirt or debris with a ph neutral cleanser and a sponge or scrub brush.
Nail 3 4 expanded metal lath to the blocks with 1 1 2 to 2 inch concrete.
You should either strip or bead blast the concrete and thoroughly clean it.
Kerdi board building panels can be used to create a ready made flat and plumb surface on the cinder block wall.
Construction board panels are extremely light and easy to cut but they provide a very strong durable and waterproof surface on which tiles will be installed.
Then flush and fill the areas with cement.
They are screwed into the wall and are waterproof and thermally insulating.
Use a flat scrap of wood to even and smoothen out the surface and let this dry for a few hours or overnight.
Rinse the cleanser away with clean water.
Had to chip off all the thinset with an electric chisel.
If the paint comes loose so does the tile.
You could set your tile right on the block if it is flat enough some block work i ve seen has convinced me that the masons were drunk on the job and there is no paint or other coatings that thinset would have a hard time bonding to.
The backerboard provided a smoother surface to tile on.
First chip the bumps cracks and dents on the concrete wall with a hammer.
Used thinset and concrete screws to install the backerboard then redguard over the backerboard before tiling.
Yet this application does make sense since concrete is heavy solid and is typically thought of as an unbending uncompromising material.
Remove as much debris as possible from the wall so the concrete.