Turn on your saw using the switch on the side of the front of the saw.
Tile saw chipping.
Guide the saw forward until you cut 1 in 2 5 cm in from the edge.
If you push the tile too fast towards the cutter you ll increase your chances of chipping the tile.
Push the tile into the saw blade approximately 1 or 2 inches depending on the size of the tile then back the tile out and turn off the saw.
Turn on your saw.
Mark the location of the cut with a marker or pencil.
Follow the below steps to do so.
As time goes on with cutting the diamonds will wear themselves to adjust to the saw.
Chipping tile when cutting with a saw happens because the blade gets worn.
Make sure the tile doesn t touch the blade before doing this.
Mark the point where you wish to notch.
This way you will prevent chipping even more.
After you ve done this you can either cut through the whole tile or cut a notch into one end and then cut the whole tile.
Angle grinders and rotary tools are effective ways to cut tile while it s still glued to the wall or floor.
Cut a 1 in 2 5 cm line along your mark with the tile face down.
It just needs a quick sharpening that you can do yourself.
Set your blade to cut all the way through the tile.
One way to avoid chipping your porcelain tile is to notch the tile before you cut through it.
To make a notch on the end of your tile.
If it is a small tile cut only 1 inch in from the.
Do not touch the blade to the tile.
A great way to avoid chipping on porcelain tiles is to notch the tile before cutting through.
Flip your tile over so the finished side faces the bottom of your saw.
Fix a piece of masking tape along the mark to make the line easier to follow and help prevent chipping.
Mark your tile where you want the notch to be.
Set your tile on the platform with the mark facing your diamond blade.
Turn on the saw push the tile slowly through the blade and get the shallow cut done.
Set your blade so that this time it will cut through the whole remaining thickness of the tile.
Turn the saw on.
Use a spray bottle to wet the tile with water to reduce dust.
I will show you what yo.
A little wobble or slight off centering of the blade to the arbor will create chipping.
If the wet saw s tray moves toward the cutter slowly cut the tile towards the blade and ensuring that the saw is constantly getting sprayed with water from the pump.
You have to be very patient in cutting tiles whether it is a wet saw or a manual tile cutter.
